MDX hardsuit (VERSION 7)
Protected under Creative Commons License.
NO COMMERCIAL REPRODUCTION ALLOWED
STL files here:
---------------------------------------------------------------------
https://drive.google.com/drive/folders/1No1mu-SDsXJVK-bjA8LUZTqa5JsCt3BD?usp=sharing
---------------------------------------------------------------------
** THE AMMO BELT MUST BE PRINTED WITOUT SUPPORT OR ANY TYPE OF ADHESION FEATURE. ***
The model is a 3D printable action figure. It will require:
- Superglue (Cyanoacrelate)
- M3 nuts and bolts in 10 mm. 15 mm. and 20. mm
- Knife, 3 mm. hand drill and files to clean and polish the parts
NOTE:
- Version 7 parts are backward compatible with version 6
- Duplicated parts and Left / Right duplications will only have ONE file. You will need to print out the copies yourself
- Hex socketed bolt work best, but feel free to try flat or Phillips
- MOST parts should print fine on FDM printer with minimal support
- Scaled up or down the print will make the model incompatible with M3 bolts
- Go slow when tigtening up the bolt at the joint.You may damage the plastic parts